These Traeger Smoked Salmon Fillets are first dry brined and cured overnight then seasoned with a simple but sweet BBQ rub.We then show you step by step how to slow smoke the salmon to perfection on a Traeger pellet grill.
Wood Pellets preferably a fruitwood like apple or cherry; or oak
Fillet or Boning Knife
Tweezers
Cutting Board
Paper Towels
Baking Dish
Plastic Wrap or Lid to Baking Dish
Large Baking Sheet with Wire Rack
Instant Read and/or Leave in Probe Thermometer
Grill Mat optional
Ingredients
12 lb Large Salmon Fillet
Dry Brine
6CupsWater
¾CupDark Brown Sugar
¼CupKosher Salt
Sweet BBQ Rub
1tablespoonDark Brown Sugar
1tablespoonSmoked Paprika
1tablespoonDried Basil
½teaspoonGarlic Powder
1teaspoonKosher Salt
1teaspoonCoarse Ground Black Pepper
Zest of ½ Lemonoptional for brightness
BBQ Sauce
½cupBlues Hog Champion Blendor your favorite BBQ sauce
Instructions
Rinse, Dry, and Fillet the Salmon
Rinse the salmon under cold running water.
1 2 lb Large Salmon Fillet
Place it on your cutting board and pat it very dry with paper towels
Once it is dry, run your fingers along the salmon checking for any bones that were not removed previously.
If you feel any, remove them with some tweezers and discard.
Lastly, slice your salmon into about 2 inch portion sized fillets.
Brine the Salmon
Dissolve the brine ingredients in boiling water. Chill the brine in the refrigerator.
¾ Cup Dark Brown Sugar, ¼ Cup Kosher Salt
Pour the brine in the bottom of the baking dish.
Submerge the fillets in the brine, skin side up, and then cover with more brine.
Cover the whole dish tightly with plastic wrap.
Place the baking dish in the refrigerator for at least 4-6 hours or overnight.
Rinse and Dry the Brined Salmon
After the salmon is finished brining, take the fillets out of the tray and rinse them off really well under cold running water.
Pat dry with paper towels, and place them on a wire rack to air dry.
Keep the seasoned salmon fillets on the wire rack in the refrigerator for about 1-2 hours to allow the pellicle to form on the outside.
Start the Traeger Pellet Grill
Remove the fire pot from the bottom of the Traeger and clean out any ashes left over from the last cook. Replace it and make sure it is secured in place with the clips on either side.
Load the hopper of the Traeger with your chosen wood pellets.
Turn on the Traeger and move the dial to the "Smoke" setting.
Leave the lid open for 5-7 minutes until you start seeing white billowing smoke coming out of the grill. This means the initial pellets are igniting.
Close the lid and turn the temperature dial to 180°F. Allow 10-15 minutes for the grill to stabilize at this temperature.
Clean the grill grates with a good grill brush and close the lid again.
Smoking the Salmon on the Traeger Pellet Grill
Oil the salmon skin.
Place the salmon fillets on the Traeger with the skin side DOWN if they are skin-on. No need to flip during the cook.
Smoke the salmon for about 1 hour to infuse smoke into the pellicle.
Mix the Sweet BBQ Rub Ingredients together well in a bowl. Keep the lemon handy for squeezing juice on at the end if you wish.
1 tablespoon Smoked Paprika, 1 tablespoon Dark Brown Sugar, 1 tablespoon Dried Basil, ½ teaspoon Garlic Powder, 1 teaspoon Kosher Salt, 1 teaspoon Coarse Ground Black Pepper, Zest of ½ Lemon
Sprinkle and rub the BBQ mixture over all sides of the dried salmon fillets and continue the smoking process.
Sauce the Salmon and Finish Cooking
Once the salmon has reached an internal temperature of 110-115°F, brush on the BBQ sauce.
Turn up the Traeger to 250°F.
Continue smoking the salmon, rotating occasionally, until the internal temperature reaches 145°F internally.
Carefully remove the smoked salmon from the Traeger and rest on a wire rack for a few minutes.